Apolosophy Active+ Hyaluronic Acid Serum Versus Swiss Clinic Hyaluronic Filler+

Apolosophy Active+ Hyaluronic Acid Serum Versus Swiss Clinic Hyaluronic Filler+

This hydrating serum is formulated around Inositol and Sodium Hyaluronate to hydrate skin and strengthen the skin barrier.

This hydrating serum is formulated around Sodium Hyaluronate and Hydrolyzed Hyaluronic Acid to hydrate skin and soften the look of wrinkles.

What's inside

Key Ingredients

Benefits

Ingredients Side-by-side

Water

Inositol

Glycerin

Propanediol

Sodium Hyaluronate

Hydrolyzed Hyaluronic Acid

Sodium PCA

Tetrasodium Iminodisuccinate

Citric Acid

Sodium Hydroxide

Ethylhexylglycerin

Phenoxyethanol

Water, Inositol, Glycerin, Propanediol, Sodium Hyaluronate, Hydrolyzed Hyaluronic Acid, Sodium PCA, Tetrasodium Iminodisuccinate, Citric Acid, Sodium Hydroxide, Ethylhexylglycerin, Phenoxyethanol

Lactic Acid

Water, Glycerin, Propanediol, Inositol, Phenoxyethanol, Sodium Hyaluronate, Sodium PCA, Lactic Acid, Ethylhexylglycerin, Sodium Hydroxide, Hydrolyzed Hyaluronic Acid

Reviews

Be the first to review

Alternatives

Ingredients Explained

These ingredients are found in both products.

Ingredients higher up in an ingredient list are typically present in a larger amount.

Ethylhexylglycerin is created from glycerin. It is a multitasker ingredient that:

The CIR Expert Panel found minimal skin absorption or sensitization of any kind in a safety assessment. Though this ingredient is considered well-tolerated, a small number of cases of allergic dermatitis have been published since 2002. Just be sure to patch test if you are unsure.

Industry-reported use ranges from 8% in rinse-off products and 2% in leave-on formulations.

Glycerin (or glycerol) is a compound naturally found in your skin. It's a powerhouse humectant that pulls water into the stratum corneum.

Topically, glycerin does several things at once:

Your skin makes glycerin on its own (mostly from sebaceous oil breakdown) and shuttles it to your outermost layer of skin, or your epidermis, via aquaporin-3.

Aquaporin-3 is a transporter that is essential for normal skin hydration, elasticity, and repair. Interestingly, mice lacking in AQP3 have dry and less elastic skin that can be fully corrected with glycerin.

This ingredient is non-irritating, plays well with almost every ingredient, and works across all skin types. Typical use is anywhere between 3-10% but can go up to 79% in some leave-on products.

Just know very high concentrations (>40%) can feel tacky in low humidity.

Glycerin is the name for this ingredient in American English. British English uses Glycerol/Glycerine.

Hydrolyzed Hyaluronic Acid is hyaluronic acid (HA) that is broken down into lower molecular weight fragments.

It's a humectant that pulls and holds water in the skin to help with hydration, plumpness, and reduce transepidermal water loss.

Because hydrolyzed hyaluronic acid is smaller in size, it can slip past your outermost layer of skin more easily than full-sized HA.

Most formulations will combine all sizes to get the best of both worlds.

Typical usage levels range from 0.01-1%. Any percentage higher than 2% might become goopy and tacky.

Inositol is a sugar alcohol naturally found in the human body. Our bodies use this ingredient in the process of growing new cells.

Studies show inositol to be a key component for keratinocyte growth.

Keratinocytes make up the majority of the outermost layer of skin. These cells protect our skin from UV exposure, infection, and help keep skin hydrated.

This ingredient is also considered a humectant. Humectants help hydrate the skin by drawing moisture to it.

Phenoxyethanol is one of the most widely used preservatives in skincare (and for good reason!).

It has a large spectrum of antimicrobial activity and especially effective bacteria, yeast, and mold while only having a weak effect on your skin's natural microbiome.

On a cellular level, it disrupts the cell membranes of microbes by poking holes that make the cell leak. This shuts down the chemical reactions the microbe needs to make energy so it can no longer survive.

Another perk of this ingredient is that it stays functional across a wide pH range (3-10).

You'll often see it paired with boosters like Ethylhexylglycerin; one study showed that a 1:9 ratio of Ethylhexylglycerin to Phenoxyethanol damages bacterial membranes as effectively as doubling the Phenoxyethanol concentration on its own.

Typical use concentrations range from 0.3-1% depending on the formula, and this ingredient is capped at 1% int the EU.

Safety-wise, the fear mongering does not hold up to the evidence. The EU's Scientific Committee on Consumer Safety and FDA consider it safe as a preservative at up to 1%, including for children of all ages.

Adverse systemic effects only showed up in animal studies at exposures roughly 200x higher than what people get from cosmetics. And despite its very widespread use, this ingredient is a rare sensitizer and allergic reactions are uncommon.

Propanediol is an all-star ingredient. It softens, hydrates, and smooths the skin.

It’s often used to:

Propanediol is not likely to cause sensitivity and considered safe to use. It is derived from corn or petroleum with a clear color and no scent.

Sodium Hyaluronate is the salt form of hyaluronic acid. It is a long sugar chain that is naturally found in your skin, joints, and connective tissue that maintains hydration and elasticity.

In skincare, it works as a humectant. It pulls water from the environment and deeper layers of skin and binds it to the surface.

Interestingly, the size of the molecule affects its behavior:

Some clinical evidence links low molecular weight versions to improved wrinkle depth, elasticity, anti-inflammatory effects, and barrier repair.

Many serums use a blend of both weights so you can get surface hydration plus longer-lasting and deeper effects.

You'll typically see concentrations between 0.1-2% for this ingredient.

Sodium Hydroxide is also known as lye or caustic soda. It is used to adjust the pH of products; many ingredients require a specific pH to be effective.

In small amounts, sodium hydroxide is considered safe to use. However, large amounts may cause chemical burns due to its high alkaline.

Your skin has a natural pH and acid mantle. This acid mantle helps prevent harmful bacteria from breaking through. The acid mantle also helps keep your skin hydrated.

"Alkaline" refers to a high pH level. A low pH level would be considered acidic.

Sodium PCA (the salt of PCA) is one of the most well-established humectants in skincare.

Why is it so special? Your skin already makes it naturally; it's a natural component of your skin's Natural Moisturizing Factor (NMF), or the mix of water-binding compounds inside your skin cells that keeps things soft and hydrated.

As a cosmetic ingredient, it grabs water and holds it in the upper layers of skin to smooth roughness and ease dehydration.

There's some clinical support for the NMF approach with a study showing that a cream built to mimic the skin's NMF significantly boosted hydration.

Safety-wise, this ingredient non-irritating, non-comedogenic, and non-phototoxic in testing, with minimal skin absorption.

It also works really well with other hydrators like glycerin or hyaluronic acid, and typical usage is somewhere between 0.2-4%.

Water. It's the most common cosmetic ingredient of all. You'll usually see it at the top of ingredient lists, meaning that it makes up the largest part of the product.

So why is it so popular? Water most often acts as a solvent - this means that it helps dissolve other ingredients into the formulation.

You'll also recognize water as that liquid we all need to stay alive. If you see this, drink a glass of water. Remember to stay hydrated!

Similar Comparisons