Beauty of Joseon Relief Sun : Rice + Probiotics SPF 50+ PA++++ Versus Suganda Total Defence Sunscreen SPF 50+

Beauty of Joseon Relief Sun : Rice + Probiotics SPF 50+ PA++++ Versus Suganda Total Defence Sunscreen SPF 50+

This chemical sunscreen covers the full UV range and blocks ~98% of UVB at SPF 50.

What's inside

Key Ingredients

Benefits

Concerns

Ingredients Side-by-side

Water

Dibutyl Adipate

Propanediol

Diethylamino Hydroxybenzoyl Hexyl Benzoate

Polymethylsilsesquioxane

Ethylhexyl Triazone

Niacinamide

Methylene Bis-Benzotriazolyl Tetramethylbutylphenol

Coco-Caprylate/Caprate

Caprylyl Methicone

Diethylhexyl Butamido Triazone

Glycerin

1,2-Hexanediol

Butylene Glycol

Oryza Sativa Extract

Oryza Sativa Germ Extract

Camellia Sinensis Leaf Extract

Lactobacillus/Pumpkin Ferment Extract

Bacillus/Soybean Ferment Extract

Saccharum Officinarum Extract

Macrocystis Pyrifera Extract

Cocos Nucifera Fruit Extract

Panax Ginseng Root Extract

Monascus/Rice Ferment

Behenyl Alcohol

Poly C10-30 Alkyl Acrylate

Polyglyceryl-3 Methylglucose Distearate

Decyl Glucoside

Tromethamine

Carbomer

Acrylates/C10-30 Alkyl Acrylate Crosspolymer

Sodium Stearoyl Glutamate

Polyacrylate Crosspolymer-6

Adenosine

Xanthan Gum

T-Butyl Alcohol

Tocopherol

Lactobacillus/Rice Ferment

Aspergillus Ferment

Saccharomyces/Rice Ferment Filtrate

Pentylene Glycol

Ethylhexylglycerin

Water, Dibutyl Adipate, Propanediol, Diethylamino Hydroxybenzoyl Hexyl Benzoate, Polymethylsilsesquioxane, Ethylhexyl Triazone, Niacinamide, Methylene Bis-Benzotriazolyl Tetramethylbutylphenol, Coco-Caprylate/Caprate, Caprylyl Methicone, Diethylhexyl Butamido Triazone, Glycerin, 1,2-Hexanediol, Butylene Glycol, Oryza Sativa Extract, Oryza Sativa Germ Extract, Camellia Sinensis Leaf Extract, Lactobacillus/Pumpkin Ferment Extract, Bacillus/Soybean Ferment Extract, Saccharum Officinarum Extract, Macrocystis Pyrifera Extract, Cocos Nucifera Fruit Extract, Panax Ginseng Root Extract, Monascus/Rice Ferment, Behenyl Alcohol, Poly C10-30 Alkyl Acrylate, Polyglyceryl-3 Methylglucose Distearate, Decyl Glucoside, Tromethamine, Carbomer, Acrylates/C10-30 Alkyl Acrylate Crosspolymer, Sodium Stearoyl Glutamate, Polyacrylate Crosspolymer-6, Adenosine, Xanthan Gum, T-Butyl Alcohol, Tocopherol, Lactobacillus/Rice Ferment, Aspergillus Ferment, Saccharomyces/Rice Ferment Filtrate, Pentylene Glycol, Ethylhexylglycerin

C12-15 Alkyl Benzoate

Propylene Glycol

Silica

Glyceryl Stearate

Cyclopentasiloxane

Cetearyl Olivate

Sodium Palmitoyl Proline

Nymphaea Alba Flower Extract

Physalis Angulata Extract

Bisabolol

Caprylic/Capric Triglyceride

Sodium Hyaluronate

Cetyl Alcohol

Dimethicone

Phenoxyethanol

Sodium Hyaluronate Crosspolymer

Ammonium Acryloyldimethyltaurate/Vp Copolymer

Disodium EDTA

Water, C12-15 Alkyl Benzoate, Propylene Glycol, Silica, Diethylamino Hydroxybenzoyl Hexyl Benzoate, Ethylhexyl Triazone, Methylene Bis-Benzotriazolyl Tetramethylbutylphenol, Niacinamide, Glyceryl Stearate, Cyclopentasiloxane, Cetearyl Olivate, Sodium Palmitoyl Proline, Nymphaea Alba Flower Extract, Physalis Angulata Extract, Bisabolol, Caprylic/Capric Triglyceride, Sodium Hyaluronate, Cetyl Alcohol, Dimethicone, Phenoxyethanol, Sodium Hyaluronate Crosspolymer, Ammonium Acryloyldimethyltaurate/Vp Copolymer, Decyl Glucoside, Tocopherol, Ethylhexylglycerin, Disodium EDTA, Xanthan Gum

Reviews

Be the first to review

Alternatives

Ingredients Explained

These ingredients are found in both products.

Ingredients higher up in an ingredient list are typically present in a larger amount.

Decyl Glucoside is a plant-derived surfactant and emulsion stabilizer. It is created by reacting glucose with the fatty acids from plants.

Like all surfactants, it works by lowering the surface tension between water and oil. This makes it so that dirt, sebum, and makeup can be lifted off your skin and rinsed away. It also produces a dense and creamy foam.

Because it has a neutral charge, it is compatible with a wide range of ingredients and stays stable across a broad pH range/water hardiness conditions.

Patch testing has shown it to have the lowest irritation potential among common cleansing surfactants (like SLS).

Typical use levels range from 5-20% in rinse-off cleansers.

One thing worth knowing: The American Contact Dermatitis Society named the parent family, alkyl glucosides, "Allergen of the Year" in 2017. The prevalence of allergy is pretty low but be sure to patch test if you've reacted to "gentle" or sulfate-free cleansers before.

This ingredient is fungal acne safe because the fatty alcohol portion of this ingredient is not within the C11-24 chain length that Malassezia can metabolize.

Diethylamino Hydroxybenzoyl Hexyl Benzoate (DHHB) is a chemical UV-A absorber. It is formulated for high UVA protection (320-400 nm).

DHHB is well-liked for:

DHHB has been approved by the EU, Japan, Taiwan, and South America for use up to 10%. Unfortunately, it has not been approved for use in the US or Canada due to slow regulatory processes.

This ingredient is soluble in oils, fats, and lipids.

Ethylhexyl Triazone (aka Octyl Triazone) is an oil-soluble organic UVB filter. It has peak absorption around 314 nm, right in the middle of the UVB range.

This ingredient is described as one of the most effective UVB filters available and small concentrations are enough to deliver a high SPF thanks to its strong UV absorbing power.

Formulators love it for its stability; its ability to filter UV stays practically unchanged even under intense radiation and it can also help boost the photostability of less stable filters like avobenzone.

It's also a great pick for water resistant products because it's insoluble in water and has a good affinity for keratin.

Because it's a big, heavy molecule, the European Scientific Committee has found to to have very low dermal penetration and negative results for allergenicity.

In vitro testing also showed a low absorption rate and clean results on irritation.

Typical use levels are 1-5% with 5% being the maximum in the EU, Japan, and other markets that allow it. However, this ingredient is not approved yet in the US or Canada.

Ethylhexylglycerin is created from glycerin. It is a multitasker ingredient that:

The CIR Expert Panel found minimal skin absorption or sensitization of any kind in a safety assessment. Though this ingredient is considered well-tolerated, a small number of cases of allergic dermatitis have been published since 2002. Just be sure to patch test if you are unsure.

Industry-reported use ranges from 8% in rinse-off products and 2% in leave-on formulations.

This ingredient is also known as Tinosorb M or Bisoctrizole and is a bit of an overachiever in the sunscreen world.

It's a hybrid broad-spectrum filter that covers UVA and UVB (~280-400nm) with peak absorption around 305nm for UVB or 360nm for UVA (and a tiny bit in blue-light territory as well).

One of its best party tricks is photostability; it doesn't break down with repeated sun exposure and doesn't generate free radicals in the process either. You'll also see it paired with wobbly filters like avobenzone because it helps stabilize them.

The safety profile is assuring as well. Because it's a large molecule, it doesn't easily absorb into skin and rarely causes irritation.

It's approved in the EU, Asia, and Australia up to 10% and most formulas land somewhere in the 2-10% range.

You won't find it as a sunscreen active in the US, but it can make an appearance as a formula-protecting UV-absorber.

Niacinamide is a multitasking form of vitamin B3 that strengthens the skin barrier, reduces pores and dark spots, regulates oil, and improves signs of aging.

And the best part? It's gentle and well-tolerated by most skin types, including sensitive and reactive skin.

You might have heard of "niacin flush", or the reddening of skin that causes itchiness. Niacinamide has not been found to cause this.

In very rare cases, some individuals may not be able to tolerate niacinamide at all or experience an allergic reaction to it.

If you are experiencing flaking, irritation, and dryness with this ingredient, be sure to double check all your products as this ingredient can be found in all categories of skincare.

When incorporating niacinamide into your routine, look out for concentration amounts. Typically, 5% niacinamide provides benefits such as fading dark spots. However, if you have sensitive skin, it is better to begin with a smaller concentration.

When you apply niacinamide to your skin, your body converts it into nicotinamide adenine dinucleotide (NAD). NAD is an essential coenzyme that is already found in your cells as "fuel" and powers countless biological processes.

In your skin, NAD helps repair cell damage, produce new healthy cells, support collagen production, strengthen the skin barrier, and fight environmental stressors (like UV and pollution).

Our natural NAD levels start to decline with age, leading to slower skin repair, visible aging, and a weaker skin barrier. By providing your skin niacinamide, you're recharging your skin's NAD levels. This leads to stronger, healthier, and younger looking skin.

Another name for vitamin B3 is nicotinamide. This vitamin is water-soluble and our bodies don't store it. We obtain Vitamin B3 from either food or skincare. Meat, fish, wheat, yeast, and leafy greens contain vitamin B3.

The type of niacinamide used in skincare is synthetically created.

Tocopherol is a fat-soluble antioxidant known as Vitamin E.

You'll find this ingredient in the vast majority of skincare (for good reason). It works to neutralize free radicals, or unstable molecules generated by UV exposure, pollution, and other environmental stressors, before they can cause oxidative damage to your skin cells.

Topically applied tocopherol has been shown to protect against UV damage by ramping up the skin's own natural defense enzymes.

It also acts as a skin conditioning agent; some studies show that regular topical use can improve the skin's water-binding capacity over 2-4 weeks.

This ingredient is especially loved for being a team player. When combined with Vitamin C, the photoprotective effect of both ingredients roughly doubles and the combo also helps reduce UV-induced DNA damage.

This ingredient has some brightening potential but it's more of a prevention ingredient than spot-fader. Cell studies show it can slow down melanin production but it's worth noting that it's not the most powerful brightener out there.

In formulations, it also serves as a stabilizer that helps protect other oxidation-prone ingredients from degrading.

Concentrations usually range from 0.1-1% in most leave-on products.

Water. It's the most common cosmetic ingredient of all. You'll usually see it at the top of ingredient lists, meaning that it makes up the largest part of the product.

So why is it so popular? Water most often acts as a solvent - this means that it helps dissolve other ingredients into the formulation.

You'll also recognize water as that liquid we all need to stay alive. If you see this, drink a glass of water. Remember to stay hydrated!

Xanthan gum is used as a stabilizer and thickener within cosmetic products. It helps give products a sticky, thick feeling - preventing them from being too runny.

On the technical side of things, xanthan gum is a polysaccharide - a combination consisting of multiple sugar molecules bonded together.

Xanthan gum is a pretty common and great ingredient. It is a natural, non-toxic, non-irritating ingredient that is also commonly used in food products.

Similar Comparisons